How to Order Parts

Indentify Your KilnSitter Model

There are four main KilnSitter Models. These model numbers are printed on the face of the KilnSitter unit and they are: Model K, Model P, Model LT-3, and Model LT-3K. Skutt Kilns only use the Model K and Model LT-3K units. Older kilns, and some custom kilns did not come with printed face plates. For these models it is best to call Skutt to make sure you identify the correct part.

Locate Your Part on the Correct Exploded Diagram

Once you have identified the correct KilnSitter model use the diagram that corresponds to your KilnSitter Model to identify the part you need. The parts in the diagram are numbered and correspond to the KilnSitter numbers listed in column one of the price list. If you are ordering shutoff tubes or sensing rods you will need to measure them to identify the correct part.

Measure Your Tube Assembly and Sensing Rod

Most parts are interchangeable from model to model, however the style and length of the Tube Assemblies and Sensing Rods used in KilnSitters can vary depending on the brand of kiln and kiln model. The two styles are pictured below. The "P" Style was used in Model P and Model LT-3 units whereas the "K" Style were used in the Model K and Model LT-3K units. Once you know the style you will need to measure the tube assembly as shown in the photos. When you go to purchase your part, simply choose the tube assembly that is the right size out of your parts list.
*NOTE: If your tube assembly does not look like the images below, as some Type P tubes are retro fitted with a bracket. Please call us for assistance.

Download the Kiln Sitter Manual Today

*Please Note ALL Kiln Sitters are 240 Volt Unless Marked Otherwise
 

 Measurement